Operation Manual - System Management
Quidway S6500 Series Ethernet Switches Chapter 1 File System Management
Huawei Technologies Proprietary
1-5
1.2.4 Erase Configuration Files from Flash Memory
The reset saved-configuration command can be used to erase configuration files
from Flash Memory. The system will use the default configuration parameters for
initialization when the Ethernet switch is powered on for the next time.
Perform the following configuration in user view.
Table 1-7 Erase configuration files from Flash Memory
Operation Command
Erase configuration files from Flash
Memory
reset saved-configuration
You may erase the configuration files from the Flash in the following cases:
z After being upgraded, the software does not match with the configuration files.
z The configuration files in flash are damaged. (A common case is that a wrong
configuration file has been downloaded.)
1.2.5 Configure the name of the configuration file used for the next startup.
Perform the following configuration in user view.
Table 1-8 Configure the name of the configuration file used for the next startup
Operation Command
Configure the name of the configuration
file used for the next startup
startup saved-configuration cfgfile
cfgfile is the name of the configuration file and its extension name can be “.cfg”. The file
is stored in the root directory of the storage devices.
After the above configuration, execute display command in any view to display the
running of the configuration files, and to verify the effect of the configuration.
Table 1-9 Display the information of the file used at startup
Operation Command
Display the information of the file used at
startup
display startup