Operation Manual - System Management
Quidway S6500 Series Ethernet Switches Chapter 1 File System Management
Huawei Technologies Proprietary
1-3
Table 1-3 Storage device operation
Operation Command
Format the storage device
format filesystem
1.1.5 Set the Prompt Mode of the File System
The following command can be used for setting the prompt mode of the current file
system.
Perform the following configuration in system view.
Table 1-4 File system operation
Operation Command
Set the file system prompt mode.
file prompt { alert | quiet }
1.2 Configure File Management
1.2.1 Configure File Management Overview
The management module of configuration file provides a user-friendly operation
interface. It saves the configuration of the Ethernet switch in the text format of
command line to record the whole configuration process. Thus you can view the
configuration information conveniently.
The format of configuration file includes:
z It is saved in the command format.
z Only the non-default constants will be saved
z The organization of commands is based on command views. The commands in
the same command mode are sorted in one section. The sections are separated
with a blank line or a comment line (A comment line begins with exclamation mark
“#”).
z Generally, the sections in the file are arranged in the following order: system
configuration, ethernet port configuration, vlan interface configuration, routing
protocol configuration and so on.
z It ends with “end”.
The management over the configuration files includes:
z Display the Current-configuration and Saved-configuration of Ethernet Switch
z Save the Current-configuration
z Erase configuration files from Flash Memory
To Next Page
Loading...
Need help?
General
