Huawei Quidway S6500 Series User Manual

Operation Manual - System Management
Quidway S6500 Series Ethernet Switches Chapter 3 Device management
Huawei Technologies Proprietary
3-5
Table 3-9 Enable/Disable RDRAM
Operation Command
Enable RDRAM of the device
rdram enable
Disable RDRAM of the device
rdram disable
By default, RDRAM of the device is enabled.
3.3 Specify the Switch Type
Using the product command, you can specify the switch type.
If the Salience III series engines works with the S6503 chassis without the XGbus
silkscreen, the system cannot recognize the current switch type. And then you need to
specify the switch type to S6503 by the product 6503 command. After that, if you want
to use this engine in the S6506 chassis without the XGbus silkscreen, you must specify
the switch type to S6506 by the product 6506 command after you insert the engine,
and vice versa.
3.3.1 Specify the Switch Type
Follow these procedures to set the switch type:
Table 3-10 Set the switch type
Configuration item Command Description
Enter system view <Quidway> system-view -
Set the switch type
[Quidway] product { 6503 |
6506 }
Required.
By default, the switch type
is S6506.
Return to user view [Quidway] quit -
Reboot the switch <Quidway> reboot Required
 Note:
z You must reboot the switch after specifying the switch type.
z If the Salience III series engines works with the other type of chassis, the system
can recognize the current switch type, and this configuration is not needed.

Huawei Quidway S6500 Series Specifications

General

Brand	Huawei
Model	Quidway S6500 Series
Category	Network Router
Language	English