Huawei Quidway S6500 Series User Manual

Operation Manual - Getting Started
Quidway S6500 Series Ethernet Switches Chapter 4 User Interface Configuration
Huawei Technologies Proprietary
4-10
Table 4-17 Setting the command priority
Operation Command
Set the command priority in a specified
view.
command-privilege level level view
view command
Restore the default command level in a
specified view.
undo command-privilege view view
command
 Note:
Please do not change the command level at will for it may cause inconvenience of
maintenance and operation.
4.2.6 Configuring Modem Attributes
When logging in the switch via the Modem, you can use the following commands to
configure these parameters.
Perform the following configurations in user interface (AUX user interface only) view.
Table 4-18 Configuring Modem Attributes
Operation Command
Set the interval since the system
receives the RING until CD_UP
modem timer answer seconds
Restore the default interval since the
system receives the RING until CD_UP
undo modem timer answer
Configure auto answer
modem auto-answer
Configure manual answer
undo modem auto-answer
Configure to allow call-in
modem call-in
Configure to bar call-in
undo modem call-in
Configure to permit call-in and call-out.
modem both
Configure to disable call-in and call-out
undo modem both
4.2.7 Configuring Redirection
I. send command
The following command can be used for sending messages between user interfaces.
Perform the following configuration in user view.

Huawei Quidway S6500 Series Specifications

General

Brand	Huawei
Model	Quidway S6500 Series
Category	Network Router
Language	English