Huawei Quidway S6500 Series User Manual

Operation Manual - QoS/ACL
Quidway S6500 Series Ethernet Switches Chapter 2 QoS Configuration
Huawei Technologies Proprietary
2-13
2.2.5 Setting Traffic Limit
Traffic limit refers to rate limit based on traffic. If the traffic threshold is exceeded,
corresponding measures will be taken, for example, dropping the excessive packets or
re-defining their priority levels.
I. Configuration on A Type Card
Table 2-12 Configure traffic policing
Operation Command Remarks
Enter system
view
system-view —
Enable
inbound car
inboundcar enable
Optional.
You can enable or disable the
inbound car as needed.
By default, the inbound car is
disabled.
Exit to user
view
quit —
Reboot the
switch
reboot
Optional.
You must reboot the switch to make
the inbound car settings take effect.
Enter system
view
system-view —
Configure
time range
time-range time-name
{ start-time to end-time
days-of-the-week [ from
start-time start-date ] [ to
end-time end-date ] | from
start-time start-date [ to
end-time end-date ] }
You must define the time range first
if you need to specify the time for the
ACL to take effect when defining the
ACL.
Set the traffic
classification
mode for the
switch
acl mode { ip-based |
link-based }
By default, the switch performs the
IP-based traffic classification.
ip-based: Performs the IP-based
traffic classification.
link-based: Performs the link-based
traffic classification.

Huawei Quidway S6500 Series Specifications

General

Brand	Huawei
Model	Quidway S6500 Series
Category	Network Router
Language	English