Operation Manual - Multicast Protocol
Quidway S6500 Series Ethernet Switches Chapter 6
PIM Configuration
Huawei Technologies Proprietary
6-7
Table 6-5 Configuring filtering PIM neighbors
Operation Command
Set to filter PIM neighbors
pim neighbor-policy acl-number
Remove filtering configuration
undo pim neighbor-policy
6.2.7 Limiting Number of PIM Neighbors on the Interface
The maximum number of PIM neighbors of a router interface can be configured to avoid
exhausting the memory of the router or router faults. The maximum number of PIM
neighbors of a router is defined by the system, and is not open for modification.
Please perform the following configurations in interface view.
Table 6-6 Limiting number of PIM neighbors on the interface
Operation Command
Limit number of PIM neighbors on the
interface
pim neighbor-limit limit
Restore the default configuration
undo pim neighbor-limit
By default, the upper limit of PIM neighbors of an interface is 128.
If the number of PIM neighbors of an interface has exceeded the configured value by
the time of configuration, existing PIM neighbors will not be deleted.
6.2.8 Clearing PIM Routing Entries
Please perform the following configurations in user view.
Table 6-7 Clearing PIM routing entries
Operation Command
Clear PIM
routing
entries
reset pim routing-table { all | { group-address [ mask { group-mask |
group-mask-length } ] | source-address [ mask { source-mask |
mask-length source-mask-length } ] | { incoming-interface
{ interface-type interface-number | null } } } * }
6.2.9 Clearing PIM Neighbors
Please perform the following configuration in user view.
To Next Page
Loading...
Need help?
General
