EasyManuals Logo

Huawei Quidway S6500 Series User Manual

Huawei Quidway S6500 Series
647 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #600 background imageLoading...
Page #600 background image
Operation Manual - System Management
Quidway S6500 Series Ethernet Switches Chapter 7 NTP Configuration
Huawei Technologies Proprietary
7-6
Perform the following configurations in VLAN interface view.
Table 7-5 Configure NTP multicast server mode
Operation Command
Configure NTP multicast server mode
ntp-service multicast-server
[ ip-address ] [ authentication-keyid
keyid ] [ ttl ttl-number ] [ version
number ]
Cancel NTP multicast server mode
undo ntp-service multicast-server
NTP version number number ranges from 1 to 3 and defaults to 3; the authentication
key ID keyid ranges from 0 to 4294967295; ttl-number of the multicast packets ranges
from 1 to 255; And the multicast IP address defaults to 224.0.1.1.
This command can only be configured on the interface where the NTP multicast packet
will be transmitted.
VI. Configure NTP Multicast Client Mode
Designate an interface on the local Ethernet Switch to receive NTP multicast messages
and operate in multicast client mode. The local Ethernet Switch listens to the multicast
from the server. When it receives the first multicast packets, it starts a brief client/server
mode to switch messages with a remote server for estimating the network delay.
Thereafter, the local Ethernet Switch enters multicast client mode and continues
listening to the multicast and synchronizes the local clock by the arrived multicast
message.
Perform the following configurations in VLAN interface view.
Table 7-6 Configure NTP multicast client mode
Operation Command
Configure NTP multicast client mode ntp-service multicast-client [ ip-address ]
Cancel NTP multicast client mode
undo ntp-service multicast-client
Multicast IP address ip-address defaults to 224.0.1.1; This command can only be
configured on the interface where the NTP multicast packets will be received.
7.2.2 Configure NTP ID Authentication
Enable NTP authentication, set MD5 authentication key, and specify the reliable key. A
client will synchronize itself by a server only if the serve can provide a reliable key.
Perform the following configurations in system view.

Table of Contents

Other manuals for Huawei Quidway S6500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Huawei Quidway S6500 Series and is the answer not in the manual?

Huawei Quidway S6500 Series Specifications

General IconGeneral
BrandHuawei
ModelQuidway S6500 Series
CategoryNetwork Router
LanguageEnglish

Related product manuals