Operation Manual - Multicast Protocol
Quidway S6500 Series Ethernet Switches Chapter 6
PIM Configuration
Huawei Technologies Proprietary
6-19
[Quidway-vlan-interface11] quit
[Quidway] vlan 12
[Quidway-vlan12] port ethernet 0/6 to ethernet 0/7
[Quidway-vlan12] quit
[Quidway] interface vlan-interface 12
[Quidway-vlan-interface12] igmp enable
[Quidway-vlan-interface12] pim sm
[Quidway-vlan-interface12] quit
6.6 PIM Troubleshooting
Fault: The router fails to establish the multicast routing table.
Troubleshooting: Follow the steps below:
Make sure that the unicast routes are correct before settling to the problem.
z PIM-SM requires support from the RP and the BSR. Use the display pim bsr-info
command to check for BSR information. If none, check for the unicast routes
towards the BSR. Then use the display pim rp-info command to check for RP
information. If none, also check the unicast routes.
z Use the display pim neighbor command to check whether the neighbor
relationship has been established correctly.
To Next Page
Loading...
Need help?
General
