Huawei Quidway S6500 Series User Manual

Operation Manual - System Management
Quidway S6500 Series Ethernet Switches Chapter 5 SNMP Configuration
Huawei Technologies Proprietary
5-7
Table 5-10 Set/Delete an SNMP Group
Operation Command
Setting an SNMP group
snmp-agent group { v1 | v2c } group-name
[ read-view read-view ] [ write-view write-view ]
[ notify-view notify-view ] [ acl acl-list ]
snmp-agent group v3 group-name [ authentication |
privacy ] [ read-view read-view ] [ write-view
write-view ] [notify-view notify-view ] [ acl acl-list ]
Deleting an SNMP group
undo snmp-agent group { v1 | v2c } group-name
undo snmp-agent group v3 group-name
[ authentication | privacy ]
5.3.10 Set the Source Address of Trap
You can use the following commands to set or remove the source address of the trap.
Perform the following configuration in system view.
Table 5-11 Set the source address of trap
Operation Command
Set the Source Address of Trap
snmp-agent trap source
interface-name interface-num
Remove the source address of trap undo snmp-agent trap source
5.3.11 Add/Delete a User to/from an SNMP Group
You can use the following commands to add or delete a user to/from an SNMP group.
Perform the following configuration in system view.
Table 5-12 Add/Delete a user to/from an SNMP group
Operation Command
Add a user to
an SNMP
group.
snmp-agent usm-user { v1 | v2c } username groupname [ acl
acl-list ]
snmp-agent usm-user v3 username groupname
[ authentication-mode { md5 | sha } authpassstring
[ privacy-mode { des56 privpassstring } ] ] [ acl acl-list ]
Delete a user
from an SNMP
group.
undo snmp-agent usm-user { v1 | v2c } username groupname
undo snmp-agent usm-user v3 username groupname { local |
engineid engine-id }

Huawei Quidway S6500 Series Specifications

General

Brand	Huawei
Model	Quidway S6500 Series
Category	Network Router
Language	English