Operation Manual - STP
Quidway S6500 Series Ethernet Switches Chapter 1 MSTP Region-configuration
Huawei Technologies Proprietary
1-28
more (as if the link to the port is disconnected). If the port has not received any
higher-priority BPDU for a certain period of time thereafter, it will resume the normal
state.
When configure a port, only one configuration can be effective among loop protection,
Root protection and Edge port configuration at same moment.
By default, the switch does not enable BPDU protection or Root protection.
By default, the protection from TC-BPDU packet attack is enabled.
For more about the configuration commands, refer to the Command Manual.
1.2.16 Enable MSTP on the Device
You can use the following command to enable MSTP on the device.
Perform the following configuration in system view.
Table 1-26 Enable/Disable MSTP on a device
Operation Command
Enable MSTP on a device.
stp enable
Disable MSTP on a device.
stp disable
Restore the disable state of MSTP, as defaulted.
undo stp
Only if MSTP has been enabled on the device will other MSTP configurations take
effect.
By default, MSTP is disabled.
1.2.17 Enable/Disable MSTP on a Port
You can use the following command to enable/disable MSTP on a port. You may
disable MSTP on some Ethernet ports of a switch to spare them from spanning tree
calculation. This is a measure to flexibly control MSTP operation and save the CPU
resources of the switch.
MSTP can be enabled/disabled on a port through the following ways.
I. Configure in system view
Perform the following configuration in system view.
To Next Page
Loading...
Need help?
General
