Operation Manual - System Management
Quidway S6500 Series Ethernet Switches Chapter 4 System Maintenance and Debugging
Huawei Technologies Proprietary
4-23
information with the level below it will not be output. channel-number specifies the
channel number and channel-name specifies the channel name.
When defining the information sent to log buffer, channel-number or channel-name
must be set to the channel that corresponds to Console direction.
Every channel has been set with a default record, whose module name is default and
the module number is 0xffff0000. However, for different channels, the default record
may have different default settings of log, trap and debugging. When there is no
specific configuration record for a module in the channel, use the default one.
 Note:
If you want to view the debugging information of some modules on the switch, you must
select debugging as the information type when configuring information source,
meantime using the debugging command to turn on the debugging switch of those
modules.
You can use the following commands to configure log information, debugging
information and the time-stamp output format of trap information.
Perform the following operation in system view:
Table 4-37 Configuring the output format of time-stamp
Operation Command
Configure the output format of
the time-stamp
info-center timestamp {
log | trap | debugging }
{ boot | date | none }
Output time-stamp is disabled
undo info-center timestamp { log | trap |
debugging }
4.5.7 Sending the Information to Trap Buffer
To send configuration information to trap buffer, follow the steps below:
1) Enabling info-center
Perform the following operation in system view.
Table 4-38 Enabling/disabling info-center
Operation Command
Enable info-center info-center enable
Disable info-center undo info-center enable
To Next Page
Loading...
Need help?
General
