Operation Manual - System Management
Quidway S6500 Series Ethernet Switches Chapter 4 System Maintenance and Debugging
Huawei Technologies Proprietary
4-28
Table 4-46 Enable/disable info-center
Operation Command
Enable info-center info-center enable
Disable info-center undo info-center enable
2) Turn on the information synchronization switch
Perform the following operation in system view.
Table 4-47 Turn on/off the information synchronization switch of every switch
Operation Command
Turn on the information synchronization
switch of the specified switch
info-center switch-on { unit-id | master |
all } [ debugging | logging | trapping ]*
Turn off the information synchronization
switch of the specified switch
undo info-center switch-on { unit-id |
master | all } [ debugging | logging |
trapping ]*
You can turn on/off the synchronization switch of the specified information on the
specified switch as needed.
By default, the log, debugging and trap information synchronization switch of master in
Fabric are all turned on. The log, debugging and trap information synchronization
switch of other switches are turned on.
4.5.10 Displaying and Debugging Info-center
After the above configuration, performing the display command in any view, you can
view the running state of the info-center. You also can authenticate the effect of the
configuration by viewing displayed information. Performing the reset command in user
view, you can clear statistics of info-center.
Perform the following operation in user view. The display command still can be
performed in any view.
Table 4-48 Displaying and debugging info-center
Operation Command
Display the content of information channel
display channel [ channel-number |
channel-name ]
Display configuration of system log and
memory buffer
display info-center
To Next Page
Loading...
Need help?
General
