Huawei Quidway S6500 Series - Setting the RADIUS Server State; Setting the Supported Type of the RADIUS Server

Operation Manual - Security
Quidway S6500 Series Ethernet Switches
Chapter 2 AAA and RADIUS Protocol
Configuration
Huawei Technologies Proprietary
2-20
II. Configuration preparations
Create the RADIUS scheme and configure the RADIUS authentication/accounting
server in the scheme as CAMS.
III. Configuration tasks
The following table describes the user Re-authentication at reboot configuration tasks.
Table 2-25 User Re-authentication at reboot configuration
Item Command Description
Enter system view system-view ––
Enter RADIUS scheme view
radius scheme
radius-scheme-name
––
Enable user re-authentication
at reboot
accounting-on enable
By default, this feature
is not enabled.
2.3.7 Setting the Supported Type of the RADIUS Server
Quidway Series Ethernet Switches support the standard RADIUS protocol and the
extended RADIUS service platforms developed by Huawei.
You can use the following command to set the supported types of RADIUS servers.
Perform the following configurations in RADIUS scheme view.
Table 2-26 Setting the supported type of the RADIUS server
Operation Command
Setting the Supported Type of RADIUS
Server
server-type { huawei | standard }
Restore the RADIUS server type to the
default setting
undo server-type
By default, the newly created RADIUS scheme supports the server of standard type,
while the "system" RADIUS scheme created by the system supports the server of
huawei type.
2.3.8 Setting the RADIUS Server State
For the primary and second servers (no matter it is an authentication/authorization
server or accounting server), if the primary is disconnected to NAS for some fault, NAS
will automatically turn to exchange packets with the second server. However, after the
primary one recovers, NAS will not resume the communication with it at once, instead,
it continues communicating with the second one. When the second one fails to