EasyManuals Logo

Huawei Quidway S6500 Series User Manual

Huawei Quidway S6500 Series
647 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #406 background imageLoading...
Page #406 background image
Operation Manual - STP
Quidway S6500 Series Ethernet Switches Chapter 1 MSTP Region-configuration
Huawei Technologies Proprietary
1-14
Generally, if there is STP switch on the switching network, the port connected to it will
automatically transit from MSTP mode to STP-compatible mode. But the port cannot
automatically transit back to MSTP mode after the STP switch is removed.
By default, MSTP runs in MSTP mode.
1.2.4 Configure the Bridge Priority for a Switch
Whether a switch can be elected as the spanning tree root depends on its Bridge
priority. The switch configured with a smaller Bridge priority is more likely to become the
root. An MSTP switch may have different priorities in different STIs.
You can use the following command to configure the Bridge priorities of the Designated
bridge in different STIs.
Perform the following configuration in system view.
Table 1-6 Configure the Bridge priority for a switch
Operation Command
Configure the Bridge priority of the
Designated bridge.
stp [ instance instance-id ] priority
priority
Restore the default Bridge priority of the
Designated bridge.
undo stp [ instance instance-id ]
priority
When configuring the switch priority with the instance instance-id parameter as 0, you
are configuring the CIST priority of the switch.
Caution:
In the process of spanning tree root election, of two or more switches with the lowest
Bridge priorities, the one has a smaller MAC address will be elected as the root.
By default, the switch Bridge priority is 32768.
1.2.5 Configure the Max Hops in an MST Region
The scale of MST region is limited by the max hops in an MST region, which is
configured on the region root. As the BPDU traveling from the spanning tree root, each
time when it is forwarded by a switch, the max hops is reduced by 1. The switch
discards the configuration BPDU with 0 hops left. This makes it impossible for the
switch beyond the max hops to take part in the spanning tree calculation, thereby
limiting the scale of the MST region.

Table of Contents

Other manuals for Huawei Quidway S6500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Huawei Quidway S6500 Series and is the answer not in the manual?

Huawei Quidway S6500 Series Specifications

General IconGeneral
BrandHuawei
ModelQuidway S6500 Series
CategoryNetwork Router
LanguageEnglish

Related product manuals