Operation Manual - Security
Quidway S6500 Series Ethernet Switches
Chapter 2 AAA and RADIUS Protocol
Configuration
Huawei Technologies Proprietary
2-26
Table 2-37 Configuring the quiet time interval
Operation Command
Set the quiet time interval
timer quiet minutes
Set the quiet time interval to its default value
undo timer quiet
By default, the value of the Quiet time interval is five minutes.
2.4 Displaying and Debugging AAA and RADIUS Protocol
After the above configuration, execute display command in any view to display the
running of the AAA and RADIUS configuration, and to verify the effect of the
configuration. Execute reset command in user view to reset AAA and RADIUS
statistics, etc . Execute debugging command in user view to debug AAA and RADIUS.
Table 2-38 Displaying and debugging AAA and RADIUS protocol
Operation Command
Display the configuration information
of the specified or all the ISP
domains.
display domain [ isp-name ]
Display related information of user’s
connection
display connection [ access-type dot1x |
domain domain-name | interface
interface-type interface-number | ip
ip-address | mac mac-address |
radius-scheme radius-scheme-name |
vlan vlanid | ucibindex ucib-index |
user-name user-name ]
Display related information of the
local user
display local-user [ domain isp-name |
idle-cut { disable | enable } | service-type
{ telnet | ftp | lan-access | ssh | terminal }
| state { active | block } | user-name
user-name | vlan vlan-id ]
Display the statistics of local RADIUS
authentication server
display local-server statistics
Display the configuration information
of RADIUS schemes
display radius [ radius-scheme-name ]
Display the statistics of RADIUS
packets
display radius statistics
Display the stopping accounting
requests saved in buffer without
response
display stop-accounting-buffer
{ radius-scheme radius-scheme-name |
session-id session-id | time-range
start-time stop-time | user-name
user-name }