Operation Manual - System Management
Quidway S6500 Series Ethernet Switches Chapter 4 System Maintenance and Debugging
Huawei Technologies Proprietary
4-21
Table 4-32 Configuring the output format of time-stamp
Operation Command
Configure the output format of the
time-stamp
info-center timestamp {
log | trap |
debugging } { boot | date | none }
Output time-stamp is disabled
undo info-center timestamp { log | trap |
debugging }
4) Enabling terminal display function
To view the output information at the Telnet terminal or dumb terminal, you must first
enable the corresponding log, debugging and trap information functions at the switch.
For example, if you have set the log information as the information sent to the Telnet
terminal or dumb terminal, now you need to use the terminal logging command to
enable the terminal display function of log information on the switch, then you can view
the information at the Telnet terminal or dumb terminal.
Perform the following operation in user view:
Table 4-33 Enabling terminal display function
Operation Command
Enable terminal display function of log, debugging and
trap information
terminal monitor
Disable terminal display function of the above
information
undo terminal monitor
Enable terminal display function of debugging
information
terminal debugging
Disable terminal display function of debugging
information
undo terminal debugging
Enable terminal display function of log information
terminal logging
Disable terminal display function of log information
undo terminal logging
Enable terminal display function of trap information
terminal trapping
Disable terminal display function of trap information
undo terminal trapping
4.5.6 Sending the Information to Log Buffer
To send configuration information to log buffer, follow the steps below:
1) Enabling info-center
Perform the following operation in system view.
To Next Page
Loading...
Need help?
General
