Operation Manual - Security
Quidway S6500 Series Ethernet Switches
Chapter 2 AAA and RADIUS Protocol
Configuration
Huawei Technologies Proprietary
2-24
You can use either command to bind a source address with the NAS.
By default, no source address is specified and the source address of a packet is the
address of the interface where it is sent.
2.3.14 Setting the Timers of the RADIUS Server
I. Setting the Response Timeout Timer of the RADIUS Server
After RADIUS (authentication/authorization or accounting) request packet has been
transmitted for a period of time, if NAS has not received the response from RADIUS
server, it has to retransmit the request to guarantee RADIUS service for the user.
You can use the following command to set response timeout timer of RADIUS server.
Perform the following configurations in RADIUS scheme view.
Table 2-33 Setting the response timeout timer of the RADIUS server
Operation Command
Set response timeout timer of RADIUS server
timer seconds
Restore the response timeout timer of RADIUS server to
default value
undo timer
By default, timeout timer of RADIUS server is 3 seconds.
II. Setting a Real-time Accounting Interval
To implement real-time accounting, it is necessary to set a real-time accounting interval.
After the attribute is set, NAS will transmit the accounting information of online users to
the RADIUS server regularly.
You can use the following command to set a real-time accounting interval.
Perform the following configurations in RADIUS scheme view.
Table 2-34 Setting a real-time accounting interval
Operation Command
Set a real-time accounting
interval
timer realtime-accounting minutes
Restore the default value of the
interval
undo timer realtime-accounting
The parameter minutes specifies the real-time accounting interval in minutes. The
value shall be a multiple of 3.
The value of minute is related to the performance of NAS and RADIUS server. The
smaller the value is, the higher the performances of NAS and RADIUS are required.
To Next Page
Loading...
Need help?
General
