Huawei Quidway S6500 Series User Manual

Operation Manual - System Management
Quidway S6500 Series Ethernet Switches Chapter 4 System Maintenance and Debugging
Huawei Technologies Proprietary
4-19
4.5.5 Sending the Information to Telnet Terminal or Dumb Terminal
To send configuration information to Telnet terminal or dumb terminal, follow the steps
below:
1) Enabling info-center
Perform the following operation in system view.
Table 4-29 Enable/disable Info-center
Operation Command
Enable info-center info-center enable
Disable info-center undo info-center enable
 Note:
Info-center is enabled by default. After info-center is enabled, system performances are
affected when the system processes much information because of information
classification and outputting.
2) Configuring to output information to Telnet terminal or dumb terminal
Perform the following operation in system view.
Table 4-30 Configuring to output information to Telnet terminal or dumb terminal
Operation Command
Output information to Telnet terminal or
dumb terminal
info-center monitor channel
{ channel-number | channel-name }
Cancel the configuration of outputting
information to Telnet terminal or dumb
terminal
undo info-center monitor channel
3) Configuring information source on the switch
By this configuration, you can define the information that sent to Telnet terminal or
dumb terminal is generated by which modules, information type, information level, and
so on.
Perform the following operation in system view:

Huawei Quidway S6500 Series Specifications

General

Brand	Huawei
Model	Quidway S6500 Series
Category	Network Router
Language	English