Huawei Quidway S6500 Series - Page 366

Operation Manual - QoS/ACL
Quidway S6500 Series Ethernet Switches Chapter 2 QoS Configuration
Huawei Technologies Proprietary
2-14
Operation Command Remarks
Enter ACL
view
acl { number acl-number |
name acl-name [ advanced
| basic | link ] }
[ match-order { config |
auto } ]
The prompt character in ACL view
corresponds to the ACL type you
enter.
Advanced
ACL:[Quidway-acl-adv-xxxx]
Basic ACL:
[Quidway-acl-basic-xxxx]
Link layer ACL:
[Quidway-acl-link-xxxx]
Define ACL
Advanced ACL:
rule [ rule-id ] { permit |
deny } protocol [ source
{ source-addr wildcard |
any } ] [ destination
{ dest-addr dest-mask |
any } ] [ source-port
operator port1 [ port2 ] ]
[ destination-port operator
port1 [ port2 ] ] [ icmp-type
type code ] [ established ]
[ [ precedence precedence
| tos tos ]* | dscp dscp ]
[ fragment ] [ time-range
name ]
Basic ACL:
rule [ rule-id ] { permit |
deny } [ source
{ source-addr wildcard |
any } | fragment |
time-range name ]*
Link layer ACL:
rule [ rule-id ] { permit |
deny } [ protocol-type
|
format-type | cos cos |
ingress { { source-vlan-id |
source-mac-addr }* | any } |
egress { dest-mac-addr |
any } | time-range name ]*
The commands defining the ACL
rules correspond to the ACL types.
Exit to system
view
quit —
Enter
Ethernet port
view
interface { interface_type
interface_num |
interface_name }
The prompt character in Ethernet
port view corresponds to the
Ethernet port you enter.
Enter QoS
view
qos
The prompt character in QoS view
corresponds to the Ethernet port
you enter.