Huawei Quidway S6500 Series User Manual

Operation Manual - System Management
Quidway S6500 Series Ethernet Switches Chapter 7 NTP Configuration
Huawei Technologies Proprietary
7-12
# Enter system view.
<Quidway2> system-view
# Set Quidway1 as the NTP server.
[Quidway2] ntp-service unicast-server 1.0.1.11
The above examples synchronized Quidway2 by Quidway1. Before the
synchronization, the Quidway2 is shown in the following status:
[Quidway2] display ntp-service status
Service status: enabled
Clock status: unsynchronized
clock stratum: 16
reference clock ID: none
nominal frequency: 100.0000 Hz
actual frequency: 100.0000 Hz
clock precision: 2^17
clock offset: 0.0000 ms
root delay: 0.00 ms
root dispersion: 0.00 ms
peer dispersion: 0.00 ms
reference time: 00:00:00.000 UTC Jan 1 1900(00000000.00000000)
After the synchronization, Quidway2 turns into the following status:
[Quidway2] display ntp-service status
Service status: enabled
Clock status: synchronized
Clock stratum: 3
Reference clock ID: 1.0.1.11
Nominal frequency: 60.0002 Hz
Actual frequency: 60.0002 Hz
Clock precision: 2^17
Clock offset: -9.8258 ms
Root delay: 27.10 ms
Root dispersion: 49.29 ms
Peer dispersion: 10.94 ms
Reference time: 19:21:32.287 UTC Oct 24 2004(C5267F3C.49A61E0C)
By this time, Quidway2 has been synchronized by Quidway1 and is at stratum 3, higher
than Quidway1 by 1.
Display the sessions of Quidway2 and you will see Quidway2 has been connected with
Quidway1.
[Quidway2] display ntp-service sessions
source reference stra reach poll now offset delay disper

Huawei Quidway S6500 Series Specifications

General

Brand	Huawei
Model	Quidway S6500 Series
Category	Network Router
Language	English