Operation Manual - STP
Quidway S6500 Series Ethernet Switches Chapter 2 BPDU Tunnel Configuration
Huawei Technologies Proprietary
2-4
3) Configure Switch C
# Enable MSTP on the device.
[Quidway] stp enable
# Enable BPDU Tunnel on the device.
[Quidway] vlan-vpn tunnel
# Add port Ethernet4/0/1 into VLAN 10.
[Quidway] vlan 10
[Quidway-Vlan10] port Ethernet 4/0/1
# First disable the STP protocol and then enable VLAN VPN on Ethernet4/0/2.
[Quidway] interface Ethernet 4/0/2
[Quidway-Ethernet4/0/2] stp disable
[Quidway-Ethernet4/0/2] vlan-vpn enable
# Set the link type of the port to trunk.
[Quidway-Ethernet4/0/2] port link-type trunk
# Add the trunk port into all VLANs.
[Quidway-Ethernet4/0/2] port trunk permit vlan all
4) Configure Switch D
# Enable MSTP on the device.
[Quidway] stp enable
# Enable BPDU Tunnel on the device.
[Quidway] vlan-vpn tunnel
# Add port Ethernet 3/0/2 into VLAN 10.
[Quidway] vlan 10
[Quidway-Vlan10] port Ethernet 3/0/2
# First disable the STP protocol and then enable VLAN VPN on Ethernet3/0/1.
[Quidway] interface Ethernet 3/0/1
[Quidway-Ethernet3/0/1] stp disable
[Quidway-Ethernet3/0/1] vlan-vpn enable
# Set the link type of the port to trunk.
[Quidway-Ethernet3/0/1] port link-type trunk
# Add the trunk port into all VLANs.
[Quidway-Ethernet3/0/1] port trunk permit vlan all
To Next Page
Loading...
Need help?
General
