Operation Manual - Reliability
Quidway S6500 Series Ethernet Switches Chapter 1 VRRP Configuration
Huawei Technologies Proprietary
1-12
III. Configuration procedure
1) Configure switch A.
# Configure VLAN 2.
[LSW-A] vlan 2
[LSW-A-vlan2] interface vlan 2
[LSW-A-vlan-interface2] ip address 202.38.160.1 255.255.255.0
[LSW-A-vlan-interface2] quit
# Set the virtual IP address of the virtual router can be pinged successfully.
[LSW-A ] vrrp ping-enable
# Create a virtual router.
[LSW-A] interface vlan 2
[LSW-A-vlan-interface2] vrrp vrid 1 virtual-ip 202.38.160.111
# Set the priority for the virtual router.
[LSW-A-vlan-interface2] vrrp vrid 1 priority 110
# Set the authentication key for the virtual router.
[LSW-A-vlan-interface2] vrrp authentication-mode md5 switch
# Set the master to send VRRP packets every 5 seconds.
[LSW-A-vlan-interface2] vrrp vrid 1 timer advertise 5
# Set the tracking interface.
[LSW-A-vlan-interface2] vrrp vrid 1 track vlan-interface 3 reduced 30
2) Configure switch B.
# Configure VLAN 2.
[LSW-B] vlan 2
[LSW-B-vlan2] interface vlan 2
[LSW-B-vlan-interface2] ip address 202.38.160.2 255.255.255.0
[LSW-B-vlan-interface2] quit
# Set the virtual IP address of the virtual router can be pinged successfully.
[LSW-B] vrrp ping-enable
# Create a virtual router.
To Next Page
Loading...
Need help?
General
