Huawei Quidway S6500 Series - Page 544

Operation Manual - System Management
Quidway S6500 Series Ethernet Switches Chapter 3 Device management
Huawei Technologies Proprietary
3-13
II. Networking diagram
Switch
PC
Network
SwitchSwitch
PC
Network
Figure 3-2 Networking for FTP configuration
III. Configuration procedure
1) Configure FTP server parameters on the PC: a user named as switch, password
hello, read & write authority over the Switch directory on the PC.
2) Configure the switch
# The switch has been configured with a Telnet user named as user, as 3-level user,
with password hello, requiring username and password authentication.
# Use the telnet command to log into the switch.
<Quidway>
Caution:
If the flash memory of the switch is not enough, you need to first delete the existing
programs in the flash memory and then upload the new ones.
# Type in the right command in user view to establish FTP connection, then correct
username and password to log into the FTP server.
<Quidway>
ftp 2.2.2.2
Trying ...
Press CTRL+K to abort
Connected.
220 WFTPD 2.0 service (by Texas Imperial Software) ready for new user
User(none):switch
331 Give me your password, please
Password:*****
230 Logged in successfully
[ftp]