Operation Manual - System Management
Quidway S6500 Series Ethernet Switches Chapter 4 System Maintenance and Debugging
Huawei Technologies Proprietary
4-17
2) Configuring to output information to console terminal
Perform the following operation in system view.
Table 4-25 Configuring to output information to console terminal
Operation Command
Output information to Console
info-center console
channel{ channel-number | channel-name }
Cancel the configuration of
outputting information to Console
undo info-center console channel
3) Configuring information source on the switch
By this configuration, you can define the information that sent to console terminal is
generated by which modules, information type, information level, and so on.
Perform the following operation in system view:
Table 4-26 Defining information source
Operation Command
Define information
source
info-center source { modu-name | default } channel
{ channel-number | channel-name } [ { log | trap | debug }*
{ level severity | state state }* ]
Cancel the
configuration of
information source
undo info-center source { modu-name | default } channel
{ channel-number | channel-name }
modu-name specifies the module name; default represents all the modules; level
refers to the severity levels; severity specifies the severity level of information. The
information with the level below it will not be output. channel-number specifies the
channel number and channel-name specifies the channel name.
When defining the information sent to the console terminal, channel-number or
channel-name must be set to the channel that corresponds to Console direction.
Every channel has been set with a default record, whose module name is default and
the module number is 0xffff0000. However, for different channels, the default record
may have different default settings of log, trap and debugging. When there is no
specific configuration record for a module in the channel, use the default one.
To Next Page
Loading...
Need help?
General
