Operation Manual - Port
Quidway S6500 Series Ethernet Switches Chapter 2 Link Aggregation Configuration
Huawei Technologies Proprietary
2-8
Table 2-6 Configure port priority
Operation Command
Configure port priority lacp port-priority port-priority-value
Restore the default port priority undo lacp port-priority
By default, port priority is 32768.
2.3 Display and Debug Link Aggregation
After the above configuration, execute display command in any view to display the
running of the link aggregation configuration, and to verify the effect of the
configuration.
You can also use in user view the reset command to clear LACP statistics of the port
and debugging commands to debug LACP.
Table 2-7 Display and debug link aggregation
Operation Command
Display summary
information of all
aggregation groups
display link-aggregation summary
Display detailed
information of a specific
aggregation group
display link-aggregation verbose [ agg-id ]
Display local system ID
display lacp system-id
Display detailed link
aggregation information at
the port
display link-aggregation interface { interface-type
interface-number | interface-name } [ to
{ interface-type interface-num | interface-name } ]
Clear LACP statistics at the
port
reset lacp statistics [ interface { interface-type
interface-number | interface-name } [ to
{ interface-type interface-num | interface-name } ] ]
Disable/enable debugging
LACP state machine
[ undo ] debugging lacp state [ interface
{ interface-type interface-number | interface-name }
[ to { interface-type interface-num |
interface-name } ] ] { { actor-churn | mux |
partner-churn | ptx | rx }* | all }
Disable/enable debugging
LACP packets
[ undo ] debugging lacp packet [ interface
{ interface-type interface-number | interface-name }
[ to { interface-type interface-num |
interface-name } ] ]
Disable/enable debugging
link aggregation errors
[ undo ] debugging link-aggregation error