323
Maintenance procedures 267
alternative mounted operator
interface installation
296
clean the system 309
dual touch monitor installation 300
MCU removal and replacement 284
operator interface removal and
replacement 288
remote operator interface
installation 291
replace ICC2 or ICC3 274
replace open fuse on ICC 276
thermocouple calibration 306
touch monitor removal and
replacement 280
Manual
ART function 89
boost, quick set screen 73
percent output, SPI command 265
standby, quick set screen 72
Maximum test time, mold 96
MCU removal and replacement 284
Measure, units of 148
Menus, selection 26
Modes, system 21
Mold
bake out cycles, length and
number 105
cooling enable 169
cross talk 99
diagnostic screen 93
diagnostics 93
diagnostics results 96
diagnostics test
start 95
earth leakage 104
files 47
heating 103
load setups from IMM 152
maximum test time, set 96
monitor zone settings 155
setup file
copy 51
create new 50
delete 51
discard changes 50
load existing 51
rename 52
save changes 50
save current mold file as new
file 51
transfer data to network 52
transfer data to USB storage
device 52
setup folder, create new 49
setups 47
test results values 97
testing 93
thermocouple rewiring,
automatic 99
tuning, ART 2.0 90
zone cooling time, set 95
Mold picture view
edit mode 181
exit edit mode 185
graphic 177
load graphic 178
map network drive 177
screen 177
toolbar 180
zone information panels 181
create 182
delete 185
edit 183
leader line color 184
leader line thickness 184
leader line, create 184
leader line, delete 185
move 182
Monitor zone settings 155
Mounted operator alternative interface
installation 296
Multi group view screen 55
buttons 56
change header color 57
To Next Page
Loading...
