About the Documentation
IN THIS SECTION
Documentation and Release Notes | xxi
Using the Examples in This Manual | xxi
Documentation Conventions | xxiii
Documentation Feedback | xxvi
Requesting Technical Support | xxvi
Use this guide to install hardware and perform initial software configuration, routine maintenance, and
troubleshooting for the MX2020 Universal Routing Platform. After completing the installation and basic
configuration procedures covered in this guide, refer to the Junos OS documentation for information about
further software configuration.
Documentation and Release Notes
To obtain the most current version of all Juniper Networks
®
technical documentation, see the product
documentation page on the Juniper Networks website at https://www.juniper.net/documentation/.
If the information in the latest release notes differs from the information in the documentation, follow the
product Release Notes.
Juniper Networks Books publishes books by Juniper Networks engineers and subject matter experts.
These books go beyond the technical documentation to explore the nuances of network architecture,
deployment, and administration. The current list can be viewed at https://www.juniper.net/books.
Using the Examples in This Manual
If you want to use the examples in this manual, you can use the load merge or the load merge relative
command. These commands cause the software to merge the incoming configuration into the current
candidate configuration. The example does not become active until you commit the candidate configuration.
xxi
To Next Page
Loading...
Need help?
General
