Figure 273: Installing the Standard Upper Cable Manager
SEE ALSO
Removing the MX2020 Upper Cable Manager | 617
Installing the MX2020 DC Cable Manager
NOTE: To accommodate additional clearance, you may order an extended DC cable manager
from Juniper Networks.
To install the DC cable manager (see Figure 268 on page 616):
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. Position the DC cable manager over the two slots located on both sides of the DC PDM.
3. Lift the DC cable manager slightly up while inserting the two flanges into the slots on both sides of the
DC PDM.
4. Push down to secure the DC cable manager in place.
622
To Next Page
Loading...
Need help?
General
