1.2 V 1208 mV
1.8 V 1801 mV
2.5 V 2526 mV
3.3 V 3312 mV
5.0 V 5020 mV
5.0 V RE 4995 mV
12.0 V 12123 mV
12.0 V RE 12007 mV
Bus Revision 100
FPGA Revision 271
CB 1 status:
State Online Standby
IntakeA-Zone0 Temperature 30 degrees C / 86 degrees F
IntakeB-Zone1 Temperature 25 degrees C / 77 degrees F
IntakeC-Zone0 Temperature 39 degrees C / 102 degrees F
ExhaustA-Zone0 Temperature 33 degrees C / 91 degrees F
ExhaustB-Zone1 Temperature 28 degrees C / 82 degrees F
TCBC-Zone0 Temperature 31 degrees C / 87 degrees F
Power 1
1.0 V 1015 mV
1.2 V 1211 mV
1.8 V 1814 mV
2.5 V 2545 mV
3.3 V 3345 mV
5.0 V 5066 mV
5.0 V RE 5020 mV
12.0 V 12104 mV
12.0 V RE 12046 mV
Bus Revision 100
FPGA Revision 0
SEE ALSO
Installing an MX2010 CB-RE
To install a CB-RE (seeFigure 229 on page 507):
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. Remove the CB-RE from the electrostatic bag.
505
To Next Page
Loading...
