Juniper MX2020 - Connecting AC Power to an MX2000 Router with Three-Phase Delta AC Power Distribution Modules

9. Verify that the LEDs on the PDM faceplate are lit steadily green, indicating that the AC terminal block
is receiving power.
10. Remove the ESD grounding strap from the ESD points on the chassis. Connect the strap to an approved
site ESD grounding point. See the instructions for your site.
WARNING: Do not touch the power connectors on the PDM. They can contain
dangerous voltages.
RELATED DOCUMENTATION
Installing an MX2000 Single-Phase AC Power Distribution Module | 385
Removing an MX2000 Single-Phase AC Power Distribution Module | 383
MX2000 Single-Phase AC Power Distribution Module Electrical Specifications | 186
Powering Off the AC-Powered MX2000 Router | 659
MX2000 AC Power Cord Specifications | 176
MX2000 AC Power System Electrical Specifications | 179
MX2000 Seven-Feed Single-Phase AC Power Distribution Module Description | 101
MX2000 Nine-Feed Single-Phase AC Power Distribution Module Description | 102
Connecting AC Power to an MX2000 Router with Three-Phase Delta AC
Power Distribution Modules
CAUTION: Do not mix AC and DC power modules within the same router.
WARNING: Power connections must be performed by a licensed electrician only.
You connect AC power to the router with three-phase delta AC power distribution modules (PDMs) by
connecting the AC power cord from an AC PDM to an AC power source.
295