Juniper MX2020 - Installing a Cable on an MX2020 MPC or MIC

WARNING: Do not look directly into a fiber-optic transceiver or into the ends
of fiber-optic cables. Fiber-optic transceivers and fiber-optic cable connected
to a transceiver emit laser light that can damage your eyes.
CAUTION: Do not leave a fiber-optic transceiver uncovered except when
inserting or removing cable. The safety cap keeps the port clean and prevents
accidental exposure to laser light.
4. Remove the cable from the cable manager, and detach it from the destination port.
SEE ALSO
Installing a Cable on an MX2020 MPC or MIC | 609
Installing a Cable on an MX2020 MPC or MIC
To install a MIC or an MPC cable (see Figure 264 on page 610 and Figure 265 on page 610):
1. Have ready a length of the type of cable used by the component. For cable specifications, see the MX
Series Interface Module Reference.
2. If the cable connector port is covered by a rubber safety cap, remove the cap.
WARNING: Do not look directly into a fiber-optic transceiver or into the ends
of fiber-optic cables. Fiber-optic transceivers and fiber-optic cable connected
to a transceiver emit laser light that can damage your eyes.
CAUTION: Do not leave a fiber-optic transceiver uncovered except when
inserting or removing cable. The safety cap keeps the port clean and prevents
accidental exposure to laser light.
3. Insert the cable connector into the cable connector port on the component faceplate.
609