5. Turn on the power switch to the on (|) position.
6. Verify that the PWR OK LED is lit steadily green.
Figure 199: Installing a DC Power Supply Module
SEE ALSO
MX2020DC Power Supply Module (-48 V) Description | 112
RELATED DOCUMENTATION
Preventing Electrostatic Discharge Damage to an MX2020 Router
Powering Off the DC-Powered MX2000 Router | 660
Troubleshooting the MX2000 Router Power System | 686
Maintaining the Power Supply Modules on the MX2000 Line of Routers | 418
MX2020DC Power Supply Module (-48 V) Description | 112
407
To Next Page
Loading...
