CAUTION: Avoid bending fiber-optic cable beyond its minimum bend radius.
An arc smaller than a few inches in diameter can damage the cable and cause
problems that are difficult to diagnose.
CAUTION: Do not let fiber-optic cable hang free from the connector. Do not
allow fastened loops of cable to dangle, which stresses the cable at the fastening
point.
5. Insert the other end of the cable into the destination port.
6. Repeat the previous steps for any additional cables.
7. If the component is offline (its failure indicator LED is lit), use one of the following methods to bring it
online.
•
To bring an MPC online:
•
Press and hold the corresponding online button on the craft interface until the green OK LED next
to the button lights steadily, in about 5 seconds.
•
Issue the following CLI command:
user@host>request chassis fpc slot slot-number online
For more information about the command, see the Junos OS System Basics and Services Command
Reference.
NOTE: When issuing the request chassis fpc online command, the FRU will get
power, and the system total power will decrease.
•
To bring a MIC online:
•
Press the MIC offline/online button until the MIC LED lights green.
•
Issue the following CLI command:
user@host>request chassis mic fpc-slot fpc-slot mic-slot mic-slot online
For more information about the command, see the Junos OS System Basics and Services Command
Reference.
611
To Next Page
Loading...
