Slot 1:
Current state Backup
Election priority Backup (default)
Temperature 36 degrees C / 96 degrees F
CPU temperature 32 degrees C / 89 degrees F
DRAM 16351 MB (16384 MB installed)
Memory utilization 7 percent
CPU utilization:
User 0 percent
Background 0 percent
Kernel 0 percent
Interrupt 0 percent
Idle 99 percent
Model RE-S-1800x4
Serial ID 9009094136
Start time 2013-02-19 18:06:33 PST
Uptime 14 hours, 29 minutes, 22 seconds
Last reboot reason Router rebooted after a normal shutdown.
Load averages: 1 minute 5 minute 15 minute
0.00 0.00 0.00
2. If the host subsystem is functioning as the master, switch it to backup by using the command:
user@host> request chassis routing-engine master switch
CAUTION: When you request the host subsystem master to switch to backup,
a message appears indicating that the network traffic will be interrupted while
the Packet Forwarding Engine is reinitialized.
3. On the console or other management device connected to the Routing Engine you are removing, enter
CLI operational mode and issue the following command. The command shuts down the Routing Engine
cleanly, so its state information is preserved:
user@host> request system halt
CAUTION: When you request a host subsystem halt, only one Routing Engine
will be halted. You must use the request chassis both-routing-engines command
to halt both Routing Engines.
665
To Next Page
Loading...
Need help?
General
