Wait until a message appears on the console confirming that the operating system has halted.
For more information about the command, see the Junos OS System Basics and Services Command
Reference.
3. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
4. Shut down power to the router by switching the AC or DC circuit breaker for all PDMs to the off (O)
position.
5. Disconnect power from the router.
6. Remove the cables that connect to all external devices.
7. Remove all field replaceable units (FRUs) from the router.
8. Attach the front and rear shipping covers.
CAUTION: Apply force to any other parts of chassis other than the shipping
covers can damage the chassis.
9. Remove the router from the rack.
•
Using a pallet jack with attachment:
•
Install the pallet jack attachment to a pallet jack. Position the pallet jack in front of the rack, and
unscrew and remove the mounting screws from the front mounting flange on the rack.
NOTE: The pallet jack attachment fits only on a standard pallet jack. The standard
pallet jack is approximately 48 in. (121.92 cm) deep x 27 in. (68.58 cm) wide.
•
A minimum of four people can then slide the router onto the pallet jack by using the handles on
the shipping covers. Attach the four shipping brackets and hardware to the pallet jack attachment.
Secure the brackets to the router chassis.
•
Position the router in front of the shipping crate and raise the pallet jack.
729
To Next Page
Loading...
Need help?
General
