Gocator Line Profile Sensors: User Manual
Getting Started • 30
Dual-Sensor System
In a dual-sensor system, two Gocator sensors work together to perform profiling and output the
combined results. The controlling sensor is referred to as the Main sensor, and the other sensor is
referred to as the Buddy sensor. Gocator's software recognizes three installation orientations: Opposite,
Wide, and Reverse.
A Master network controller (excluding Master 100) must be used to connect two sensors in a dual-
sensor system. Gocator Power and Ethernet to Master cordsets are used to connect sensors to the
Master.
To Next Page
Loading...
Need help?
General
