Gocator Line Profile Sensors: User Manual
Tools and Native Drivers • 711
RecordingFilter
Section1 Param 1, Section1 Param2
value, value
Section2 Param 1
value
Section3 Param1, Section3 Param2
value
End
Each section will be described by a separate table below. They appear in the same order as documented.
Field Description
Condition Combination Type Any or All
RecordingFilter Fields
Field Description
Type Any Measurement
Enabled Whether or not is enabled. Yes/No
Result Accepted result type: Pass/Fail/Invalid/Valid
"Any Measurement" Filter Fields
Field Description
Type Any Data
Enabled Whether or not is enabled: Yes/No
Threshold Case How to threshold: At or Above, or Below
Range Count Threshold Threshold value (point count)
"Any Data" Filter Fields
Field Description
Type Measurement
Enabled Whether or not is enabled: Yes/No
Result Accepted result type: Pass/Fail/Invalid/Valid
Selection ID First measurement ID
"Measurement" Filter Fields
Ranges
This section describes single-point range data. It has two sub-sections:attributes and data.
The attribute section has only one row of data
Field Description
Frame Count Total number of frames
X Offset X offset (mm)
Y Offset Y offset (mm)
Z Offset Z offset (mm)
Attribute Section Fields
To Next Page
Loading...
Need help?
General
