Gocator Line Profile Sensors: User Manual
Gocator Emulator • 468
The decision values in the exported data depend on the current state of the job, not the state
during recording. For example, if you record data when a measurment returns a pass decision,
change the measurement's settings so that a fail decision is returned, and then export to CSV,
you will see a fail decision in the exported data.
Recorded intensity data can be exported to a bitmap (.BMP format). Acquire Intensity must be
checked in the Scan Mode panel while data was being recorded in order to export intensity data.
To export recorded intensity data to the BMP format:
l Switch to Replay mode and click the Export button and select Intensity data as BMP.
Only the intensity data in the current replay location is exported.
Use the playback control buttons to move to a different replay location; for information on playback,
see To replay data in Playback and Measurement Simulation on page 464.
To export video data to a BMPfile:
1. In the Scan Mode panel, switch to Video mode.
Use the playback control buttons to move to a different replay location; for information on playback,
see To replay data in Playback and Measurement Simulation on page 464.
2. Switch to Replay mode.
3. Click the Export button and select Video data as BMP.
Downloading and Uploading Jobs
The Jobs category on the Manage page lets you manage the jobs in the emulator.
To Next Page
Loading...
Need help?
General
