Gocator Line Profile Sensors: User Manual
Gocator Web Interface • 319
Settings and Available Filters
Parameter Description
Source The sensor, or combination of sensors, that provides data for the tool's measurements. For
more information, see Source on page 201.
Can only accept Surface scan data (that is, cannot accept data from other tools).
Use Region When enabled, lets you set a region.
Region The region whose data the tool will apply filters to. Only data within the region is output to
other tools.
Use Intensity If enabled, the tool uses intensity data instead of heightmap data. Only available if Acquire
Intensity is enabled on the Scan page during the scan; for more information, see .
Number of Filters Specify the number of filters you want to chain together. You can specify up to seven filters.
Filter Type For each filter, specify the type of filter. For more information on the available filters, see
Filters below.
Kernel Size The kernel size that the filter uses. The size is represented in data points. (Not available on
all filters.)
Parameters
Name Description
Median A median filter.
Gaussian A Gaussian filter.
Open Erosion followed by dilation.
Close Dilation followed by erosion.
Erode Applies an erosion filter. Lets you specify the direction of the erosion; one of the following:
l Horizontal
l Vertical
l Symmetrical
Dilation Applies a dilation filter. Lets you specify the direction of the dilation; one of the following:
l Horizontal
l Vertical
l Symmetrical
Morph Gradient Applies a morphological gradient. The difference between dilation and erosion.
Sobel Magnitude Applies a Sobel magnitude filter.
Lets you specify the direction of the filter; one of the following:
l Horizontal
l Vertical
l Symmetrical
Filters
To Next Page
Loading...
Need help?
General
