Gocator Line Profile Sensors: User Manual
Getting Started • 46
To connect to a sensor for the first time:
1. Connect cables and apply power.
Sensor cabling is illustrated in System
Overview on page 29.
2. Change the client PC's network
settings.
Windows 7
a. Open the Control Panel, select
Network and Sharing Center,
and then click Change Adapter
Settings.
b. Right-click the network connection
you want to modify, and then click
Properties.
c. On the Networking tab, click
Internet Protocol Version 4
(TCP/IPv4), and then click
Properties.
d. Select the Use the following IP
address option.
e. Enter IP Address "192.168.1.5"
and Subnet Mask "255.255.255.0",
then click OK.
To Next Page
Loading...
Need help?
General
