Gocator Line Profile Sensors: User Manual
Tools and Native Drivers • 717
Element Description
1 Sensor selector Lets you choose among connected sensors.
2 Receiving timeout The number of seconds the transfer tool will wait to receive data from the sensor
before timing out.
3 MountainsMap component After the data transfers from the sensor to the tool, you can edit it directly in the
transfer tool.
4 Status bar Indicates whether the tool is connected to a sensor, and so on.
5 Show/hide log file Toggles display of the log file. Useful for diagnosing connection and scan issues.
6 Hide command bar Toggles display of the command bar at the top of the tool.
7 Use accelerator Attempts to accelerate the sensor chosen in the sensor selector drop-down.
In order for the tool to accelerate the sensor, the sensor's
firmware must match the Gocator SDKversion indicated on
the tool's title bar. If these versions do not match, the tool will
not be able to accelerate the sensor. In this case, you can
accelerate the sensor using the standalone accelerator
application or an SDK-based application.
8 Snapshot button Causes the connected sensor to take a snapshot. The data is then transferred to
the tool. If the tool does not receive the data before the delay specified in
Receiving timeout, the transfer fails.
To Next Page
Loading...
Need help?
General
