OPERATION
9. Engage safety props on both lift cylinders as follows:
a. Stop engine and remove key from ignition.
b. Pull lever (A) and rotate toward header to release
and lower the safety prop (B) onto cylinder.
c. Repeat for the opposite lift cylinder.
Figure 4.
144: Cylinder Stop
10. Install clevis pin (A) through each boot and foot, and
secure with hairpin. Do this to both sides.
IMPORTA
NT:
Ensure c
levis pin (A) is fully inserted and hairpin is
install
ed behind bracket.
Figur
e 4.145: Header Boot
169890 157 Revision A
To Next Page
Loading...
