NEC ELECTRA ELITE IPK II - Page 124

Electra Elite IPK II Document Revision 1
Electra Elite IPK II Programming Manual 2 - 89
20
Block Outgoing
Caller ID
Allow (1) or prevent
(0) the system from
automatically blocking
outgoing Caller ID
information when a
user places a call. If
allowed (i.e. block,
enabled), the system
automatically inserts
the Caller ID block
code (defined in
14-01-21) before the
user dialed digits.
0 = Disable
(No)
1 = Enable
(Yes)
0
14-01-21
21
Caller ID Block Code
Enter the code, up to
8 digits, that should
be used as the Caller
ID Block Code. This
code is automatically
inserted before dialed
digits if Program
14-01-20 is set to ‘1’.
Dial (up to 8
digits)
, 67
14-01-20
22
Caller ID to Voice
Mail
Enable or disable the
system’s ability to
send the Caller ID
digits (Remote
Log-On Protocol) to
voice mail.
0 = Disable
(No)
1 = Enable
(Yes)
0
23
LCR
-- Not Used in U.S. --
0 = LCR Off
(Service Off)
1 = LCR On
(Service On)
2 = Cost Center
Only
0
24
Trunk-to-Trunk
Outgoing Caller ID
through Mode
0 = Disable
(No)
1 = Enable
(Yes)
0
25
Continued/
Discontinued Trunk-
to-Trunk
Conversation
0 = Disable
(No)
1 = Enable
(Yes)
0
26
Automatic Trunk-to-
Trunk Transfer Mode
0 = Normal
Transfer (Normal)
1 = Step Transfer
(Step)
0
Item
No.
Item Input Data Default
Related
Program