Electra Elite IPK II Programming Manual 2 - 573
Program
92
Description
(This program is available only via telephone programming and not through
PC Programming).
Use Program 92-01 : Copy Program to copy the data for one program to
another multiline terminal, port, group, etc. Refer to the following charts to see
which programs can be copied.
Program 92 : Copy Program
92-01 : Copy Program
Level:
IN
Input Data
Program Number XX-XX
Item
No.
Item Input Data
01
Source Number
Enter the extension, trunk, group, etc.
from which the data will be copied.
H
In case of Trunk Base :
Trunk Port Number 1~8 or 1~200
H
In case of Trunk Group Base :
Trunk Group Number 1~8 or 1~100
H
In case of Extension Base :
Extension Number (up to 8 digits)
H
In case of Department Group Base :
Department Group Number 1~8 or
1~64
H
In case of DSS :
DSS Console Number 1~4 or 1~32
Destination Number (From)
Enter the first extension, trunk, group, etc.
number to which the information is to be
copied.
Destination Number (To)
Enter the last extension, trunk, group, etc.
number to which the information is to be
copied. If the information is only be copied
to one extension, trunk, group, etc., enter
the information entered in the Destination
Number (From) entry.
To Next Page
Loading...
