NEC ELECTRA ELITE IPK II - DID Basic Data Setup

Electra Elite IPK II Document Revision 1
Electra Elite IPK II Programming Manual 2 - 235
Description
Use Program 22-09 : DID Basic Data Setup to define the basic setting of Dial-In
incoming calls for each trunk group.
Program 22 : Incoming Call Setup
22-09 : DID Basic Data Setup
Level:
IN
Input Data
Trunk Group Number 001~100
Item
No.
Item Input Data Default
01
Expected Number of Digits
Enter the number of digits the table
expects to receive from the telco. Use this
program to make the system compatible
with three- and four-digit DID service.
1~8 4
02
Received Vacant Number Operation
Use this option to enable or disable
Vacant Number Intercept.
0 = Disconnect (Cut)
1 = Transfer (Refer to
Program 22-12 : DID
Intercept Ring Group on
page 2-243.)
0
03
Sub-Addressing Mode
0 = Extension # Specify
(Intercom)
1 = DID Conversion Table
0
04
DID Receiving Mode for ISDN
0 = Enbloc Receiving
1 = Overlap Receiving
0
05
Local Code Digits
(Only Overlap Receiving Mode)
0~15 (0 = No Local Code) 0
06
Local Code
(Only Overlap Receiving Mode)
Dial (maximum 16 digits) No Setting
07
Pilot Code
(Only Overlap Receiving Mode)
Dial (1 digit: 0~9) No Setting
08
T302 Time-out Operation
(Only Overlap Receiving Mode)
0 = Disconnect (Cut)
1 = Transfer (Refer to
Program 22-12 : DID
Intercept Ring Group on
page 2-243.)
0