NEC ELECTRA ELITE IPK II - Connecting System Settings

Document Revision 1 Electra Elite IPK II
2 - 462 Program 50 : Common Channel Interoffice Signaling Service
Description
Use Program 50-02 : Connecting System Settings to define the settings for
each CCIS Route ID.
Program 50 : Common Channel Interoffice Signaling Service
50-02 : Connecting System Settings
Level:
IN
Input Data
CCIS Route ID Route ID 1~8: CCIS via DTI
Route ID 9: CCIS via IAD (IP-CCIS)
Item
No.
Item Description Input Data Default
01
Port Number of Common
Signaling Channel (DTI
only)
Specify the Trunk port to send D-channel information.
This program is available for using DTI package.
0~200 0
02
Common Signaling
Channel Data Speed
Assignment (DTI only)
Assign the baud rate of Common Signaling Channel
on DTI package.
0 = 64Kbps
1 = 56Kbps
2 = 48Kbps(1)
3 = 48Kbps (2)
1
03
Originating Point Code
(DTI only)
Assign the Point code of own side.
0~16367 0
04
Destination Point Code Assign the Point code of destination side on the DTI
link.
0~16367 0
05
Calling Name Indication Calling name indication will not send to destination
party if switch is turned to Disable.
0 = Disable
1 = Enable
1
06
CCH Channel Number on
the CCH Package
Assingnment
0~4 (0 = No
Setting)
0