NEC ELECTRA ELITE IPK II - Class of Service Options for DISA;E&M

Electra Elite IPK II Document Revision 1
Electra Elite IPK II Programming Manual 2 - 177
Description
Use Program 20-14 : Class of Service Options for DISA/E&M to enable/disable
DISA and tie line Class of Service options. You assign a DISA Class of Service to
DISA users in Program 25-09. Assign tie line Classes of Service in 34-02. Up to 15
DISA/E&M Classes of Service can be defined.

Analog trunk-to-analog trunk and ISDN trunk-to-ISDN trunk calls are supported by this
program. However, analog trunk-to-ISDN trunk and ISDN trunk-to-analog trunk calls are
NOT supported by this program.
Program 20 : System Option Setup
20-14 : Class of Service Options for DISA/E&M
Level:
IN
Input Data
Class of Service Number 01~15
Item
No.
Item
Input
Data
Default
COS
01~14
COS
15
01
First Digit Absorbtion (Delete First Digit Dialed)
For tie lines, enable or disable the ability to absorb (ignore) the
first incoming digit. Use this to make the tie trunk compatible with
3- and 4-digit tie line service. This option does not apply to DISA.
0 = Off
1 = On
00
02
Trunk Group Routing/ARS Access
This option enables or disables a DISA or tie trunk caller’s ability
to dial 9 for Trunk Group Routing or Automatic Route Selection
(ARS).
0 = Off
1 = On
11
03
Trunk Group Access
This option enables or disables a DISA or tie trunk caller’s ability
to access trunk groups for outside calls (Service Code 704).
0 = Off
1 = On
11
04
Outgoing System Speed Dial
This option enables or disables a DISA or tie trunk caller’s ability
to use the System Speed Dialing.
0 = Off
1 = On
00
05
Operator Calling
This option enables or disables a DISA or tie trunk caller’s ability
to dial 0 for the telephone system operator.
0 = Off
1 = On
11