NEC ELECTRA ELITE IPK II - Trunk Access Code

Electra Elite IPK II Document Revision 1
Electra Elite IPK II Programming Manual 2 - 47
Description
Use Program 11-09 : Trunk Access Code to assign the trunk access code (normally 9).
The trunk access code can be set from 1 to 8 digits which is defined to type 3 and 4 in
Program 11-01. This is the code extension users dial to access Automatic Route
Selection. The Individual Trunk Access Code is used when Trunk Group Routing is
desired for an outgoing line.
Program 11 : System Numbering
11-09 : Trunk Access Code
Level:
IN
Caution!
The digit 9 is defined in Program 11-01 as Dial Type 3 with the Number of Digits
Required set to 1. If you change the trunk access code in Program 11-09, you
must make the corresponding changes in Program 11-01.
Input Data
Item
No.
Item Input Data Default Description Related Program
01
Trunk Access
Code
Dial
(up to 4
digits)
9
Use this program
to assign the trunk
access code
(normally 9). This
is the code
extension users
dial to access
Automatic Route
Selection.
H 11-01 : System
Numbering
H 14-01 : Trunk Basic
Data Setup
H 14-05 : Trunk Group
H 14-06 : Trunk Group
Routing