NEC ELECTRA ELITE IPK II - DSS Console Key Assignment

Electra Elite IPK II Document Revision 1
Electra Elite IPK II Programming Manual 2 - 297
Description
Use Program 30-03 : DSS Console Key Assignments to customize the key
assignments for 60-button DSS Consoles. A DSS Console key can have any function
up to four digits long (e.g., extension number or Service Code).
To prevent lamping problems when reassigning DSS Console keys, it is
recommended that you clear an extension's programmed key before reassigning it
[Enter key to be cleared + 00 or
, 00 (If using Web or PC Programming, delete the key
assignments and upload the change to the system before proceeding.)] Without
clearing an extension key first, the DSS Console may not show the correct lamping,
although the DSS function works correctly.
If you are programming the system from the extension to which the DSS Console is
connected, either by phone or using the Web or PC Program, you may need to unplug
the DSS and plug it back in to reset the console's lamping.
Input Data
Program 30 : DSS/DLS Console Setup
30-03 : DSS Console Key Assignment
Level:
SA
Index 1
DSS Console Number 01~32
Index 2
Item
No.
Key Number Function Number Additional Data
01 01~60 0~99 (General Functional Level)
, 00 ~ , 99 (Appearance
Functional Level)
Refer to Function Number
List on the following pages.