NEC ELECTRA ELITE IPK II - ARS Dial Treatments

Electra Elite IPK II Document Revision 1
Electra Elite IPK II Programming Manual 2 - 285
Description
Use Program 26-03 : ARS Dial Treatments to assign the 15 Dial Treatments for
automatic ARS dialing translation. Assign Dial Treatments to Service Numbers
(Trunk Groups) in Program 26-02. The ARS Dial Treatment options are:
J 3 - Delete the NPA if dialed as part of the initial call.
 Requires at least eight digits in the ARS table (Program 26-02-01).
J 2 - Delete the leading digit if dialed as part of the initial call.
 Requires at least eight digits in the ARS table (Program 26-02-01).
J 1 - Add a leading 1 if not dialed as part of the initial call.
 Requires at least eight digits in the ARS table (Program 26-02-01).
J INPA - Insert the NPA specified by NPA.
J DNN - Outdial the NN number of digits or execute the code that follows. For
example, D041234 outdials 1234. Valid entries are 0-9, #,
, , Wnn (wait nn
seconds) and P (pause). Each digits code counts as a digit. So, for example, if a P
was added for a pause, the entry would look like: D05P1234.
J Wnn - Wait nn seconds.
J P - Pause in analog trunk.
J R - Redial the initially dialed number, including any modifications.
J E - End of Dial Treatment. All Dial Treatments must end with the E code.
J X - When ARS is enabled, X must be entered in the Dial Treatment in order for the
system to output the extension number of the call’s originator to the black box for
the E911 feature.
Program 26 : ARS Service
26-03 : ARS Dial Treatments
Level:
IN